Using flashing lights that work remains mandatory. Think about it, not putting a turn signal is punishable by 3 point on your driver's license as well as a traffic ticket . Although some police officers are sometimes complacent about this. It is therefore essential to have the flashing lights in good condition. We will now see how to replace the bulb of a Seat 132 indicator, at the front and the rear. It is also conceivable that the concern is due to a short circuit, however this is relatively rare.
Seat 132: things to know before replacing your turn signal
To begin with, it is essential to carefully select the model of your bulb! In order not to be mistaken, we advise you to go to a spare parts website or to an auto repairer who can select them. Second, you will have to think about selecting the right color for the bulb. Then you will need a tools extremely basic but still necessary. You will therefore need a screwdriver for a Seat 132. A set of cruciforms and torxes and you are bound to be able to do it. Usually the bulbs are at bayonet . In order to take out the damaged bulb, you will have to turn it a quarter of a turn to the left. To put the new bulb, it is then necessary to rotate a quarter of a turn in the other direction.
How to change the bulb of a front indicator on a Seat 132
There are two main solutions that can be found in order to access the flashing lights. It depends on the different models, however accessibility can be done either from the outside or from the inside for this Seat 132. Access from inside the engine : To start, you'll have to open your hood. And then it is necessary to unscrew a cover with a screwdriver (usually torx) in order to access the headlight block. When the block is unclipped, remove it and do not hesitate to replace the bulb. Wheel arch access : Check underneath the wheel to see if the fasteners are in this location. If this is the case, it is necessary to disassemble the fasteners and remove the screws with a screwdriver. Secondly, remove the headlight unit of this Seat 132 gently from the front. You simply need to replace the bulb and position the block in the reverse order. Less frequently, for some cars it is still conceivable to remove the headlight assembly from the outside. But it is relatively rare. If this is the case, with a screwdriver you will have to remove the fasteners, release the headlight assembly slowly and replace the burnt out bulb.
How to change the bulb of a rear indicator on a Seat 132
There are also two main solutions to access the turn signal bulb. It depends on the models, however the accessibility can be done either from inside or from outside. Access from inside the trunk : In most cases, accessibility can be done from the trunk. At the level of the light blocks, there are screws and fixings. Take them out and remove the block slowly. Then it is simply necessary to replace the burnt out bulb with the new one. And then redo the same manipulation in the other direction. It is also conceivable that accessibility is from the outside or under the wheel arch. But it is much less common. In all cases, it is necessary to use your screwdriver and remove, being careful, the entire headlight unit in order to replace this bulb. To reassemble it, reverse the procedure.