Using flashing lights that are in good condition is mandatory. Think about it, omitting a flashing light is punishable by 3 point on the permit as well as a fine . Although some police are sometimes complacent about this. It is therefore essential to have flashing lights in good working order. We will therefore find out in this article how to replace the bulb of a flashing Seat Fura light, front and rear. It is also conceivable that the problem stems from a false contact, but it is relatively rare.
Seat Fura: things to know before replacing your turn signal
First of all, it is essential to select the correct bulb model! In order not to be mistaken, it is advisable to go to a spare parts site or to your professional who can select them. Then you have to think about selecting the right color for the bulb. Then you will need a tools super simple but nevertheless essential. You will need a screwdriver for a Seat Fura. A cruciform and torx kit and everything will be doable. Most of the time, the bulbs are at bayonet . In order to dismantle the faulty bulb you will have to rotate the bulb a quarter of a turn to the left. To install the new bulb, you will therefore have to rotate a quarter of a turn in the other direction.
How to change the bulb of a front indicator on a Seat Fura
There are two different ways to access the turn signals. It depends on the models, but accessibility will be done either from the outside or from the inside on your Seat Fura. Access from inside the engine : First, you will have to open your hood. Then, you will have to unscrew the cover using a screwdriver (most often torx) to access the light block. As soon as the block is unscrewed, remove it and you can replace this bulb. Wheel arch access : Inspect below the wheel to see if the clips are there. In case this is happening, you will need to remove the fasteners and remove the screws with a screwdriver. Then remove the light block of this Seat Fura slowly from the front. It is now enough to replace the bulb and reattach the light block in the opposite direction. Exceptionally, on certain models it is conceivable to remove the block of lights from the outside. But it is relatively rare. In the event that this happens, using a screwdriver you will need to remove the fixings, remove the light unit slowly and change the faulty bulb.
How to change the bulb of a rear indicator on a Seat Fura
There are also two different ways to access your turn signal bulb. It can depend on the models however the accessibility will be done either inside or outside. Access from inside the trunk : Almost every time accessibility will be through the interior of the trunk. Regarding the light units, you will find screws and fixings. Take them off and take the piece off, being careful. Then you just have to replace this faulty bulb with the new one. Then repeat the same manipulation in the other direction. It is also conceivable that accessibility is done from the outside or under the wheel arch. But it is much less frequent. In all cases, you will need to use your screwdriver and carefully remove the entire light unit so as to replace this bulb. To put it in place, carry out the opposite manipulation.