Using flashing lights which are in good condition remains compulsory. Think about it, forgetting to put a flashing light is liable to 3 point on the permit as well as a traffic ticket . Even if some police officers are sometimes kind on this point. It is therefore essential to have flashing lights that work properly. We will find out with this article how to replace the bulb of a flashing light for a Seat Ronda, front and rear. It is sometimes likely that the malfunction is due to a short circuit, however it is rather rare.change-indicator-Seat-Ronda

Seat Ronda: things to know before replacing your indicator

Above all it is wiser to choose the right type of bulb! In order not to be mistaken, we advise you to go to a spare parts website or to a garage which will be able to order them for you. Then it is necessary to think about choosing the right color for your bulb. Finally, you will need a tools very simple but still essential. You will therefore mainly need a screwdriver for a Seat Ronda. A kit of cruciform and torx and you will necessarily be able to get there. Almost every time, the bulbs are bayonet . So as to dismantle the defective bulb it will be necessary to rotate the latter by a quarter of a turn anticlockwise. In order to put the new bulb, you will have to rotate a quarter of a turn in the other direction.

How to change the bulb of a front indicator on a Seat Ronda

There are two main ways to access the turn signals. Indeed, it depends on the models, however access can be done either from the outside or from the inside on a Seat Ronda. Access from inside the engine : First, you will have to open your hood. And then, you will have to remove the cover with the help of a screwdriver (most often torx) to access the block of lights. Once the unit is unclipped, remove it and you can replace the bulb. Wheel arch access : Inspect below the wheel to see if the clips are there. If so, you will need to remove the fasteners and remove the screws with the help of your screwdriver. Then carefully remove the light block from the Seat Ronda from the front. Now you just have to replace your bulb and put the light block back in the reverse order. Exceptionally, on certain cars it is likely to remove the block of lights from the outside. Nevertheless it is rather rare. If this is the case, with the help of a screwdriver you will need to remove the fasteners, gently release the light unit and replace your burnt out bulb.

How to change the bulb of a rear indicator on a Seat Ronda

There are also two main ways to access the turn signal bulb. It may depend on the different types but access can be done either from the inside or from the outside. Access from inside the trunk : Most of the time access can be done from the trunk. Regarding the light blocks, you will find screws and fasteners. Remove them and remove the block gently. Finally you will simply have to replace the burnt out bulb with the new one. And then repeat this operation in the other direction. It is also likely that access is from the outside or under the wheel arch. However, it is much rarer. In all cases, you will have to use your screwdrivers and carefully remove the entire block of lights in order to replace your bulb. To reassemble, perform the reverse manipulation.