Having working flashing lights is a legal requirement. As a reminder, omitting a flashing light is punishable by 3 point on your driver's license as well as a traffic ticket . Although some law enforcement officials are sometimes complacent on this point. It is therefore necessary to have flashing lights in good working order. We will therefore discover with this article how to change the bulb of a Suzuki Alto 2 indicator light, front and rear. It is sometimes likely that the problem is the result of a short circuit, however this is quite rare.change-flashing-Suzuki-Alto-2

Suzuki Alto 2: things to know before changing your turn signal

To begin with, it is wiser to buy the model of your bulb! So as not to be mistaken, we advise you to go to a spare parts site or to a mechanic who will be able to select them. Secondly, you will have to think about selecting the right color for your bulb. Then you will need to use a tools very simple but still essential. You will therefore mainly need a screwdriver for a Suzuki Alto 2. A cruciform and torx kit and you will be able to do it. In most cases, the bulbs are at bayonet . In order to be able to disassemble the defective bulb you will have to turn the bulb a quarter of a turn counterclockwise. In order to fit the new bulb, it is necessary to turn a quarter of a turn in the other direction.

How to change the bulb of a front indicator on a Suzuki Alto 2

There are two different ways to access the flashing lights. It depends on the model, however accessibility can be done either from the outside or from the inside on a Suzuki Alto 2. Access from inside the engine : First, you're going to have to open the hood. And then, you will have to remove the cover using a screwdriver (often torx) to access the light unit. Now that the block is unclipped, remove the latter and do not hesitate to change this bulb. Wheel arch access : Inspect under the wheel to see if the fasteners are there. If that's it, it is necessary to undo the hooks and remove the screws with the help of your screwdriver. Secondly, remove the light block from this Suzuki Alto 2 slowly from the front. Now all you have to do is change your bulb and position the block in the opposite direction. More rarely, on some models it is likely to remove the light unit from the outside. However, it is quite rare. If that's it, using a screwdriver you will have to remove the fasteners, remove the light unit slowly and replace your faulty bulb.

How to change the bulb of a rear indicator on a Suzuki Alto 2

There are also two different ways to access this turn signal bulb. This may depend on the models, but accessibility can be done either from the inside or from the outside. Access from inside the trunk : In most cases, accessibility can be done from inside the boot. At the level of the light blocks, there are screws and fasteners. Take them out and put the piece down gently. Then you just have to replace this faulty bulb with a new one. And then repeat the same manipulation in the opposite direction. It is also likely that the accessibility could be from the outside or through the wheel arch. However, it is much rarer. In all cases, it is necessary to use your screwdrivers and carefully remove the entire light unit in order to change this bulb. To put it in place, perform the reverse manipulation.