Using flashing lights that are in good condition is mandatory. Think about it, not putting a flashing light is punishable by 3 point on the permit as well as a fine . Although some law enforcement officers are regularly complacent on this point. It is therefore essential to have the flashing lights in good condition. We will therefore discover with this article how to change the bulb of a turn signal for a Toyota Cs & s, at the front and the rear. It is sometimes conceivable that the problem is due to a short circuit, however this is relatively rare.change-turn signal-Toyota-Cs & s

Toyota Cs & s: things to know before changing your turn signal

First of all it is wiser to correctly select the model of your bulb! In order not to be mistaken, it is advisable to go to a spare parts site or to your professional who will be able to order them for you. Secondly, it is necessary to think about choosing the right color for the bulb. Thereafter, you will need a tools super basic but still necessary. You will therefore mainly need a screwdriver for a Toyota Cs & s. A set of cruciforms and torxes and everything will be doable. Usually the bulbs are bayonet . In order to be able to dismantle the defective bulb, it must be rotated a quarter of a turn anticlockwise. To fix the new bulb, it is therefore necessary to turn a quarter of a turn in the other direction.

How to change the bulb of a front turn signal on a Toyota Cs & s

There are two different ways to access the flashing lights. It depends on the model, however the access will be either from the outside or from the inside for this Toyota Cs & s. Access from inside the engine : First, you have to open the hood. And then, you will have to remove the cover with a screwdriver (regularly torx) to access the headlight unit. Now that the block is unscrewed, remove it and do not hesitate to change your bulb. Wheel arch access : Check below the wheel to see if the clips are there. If this is what happens, you have to disassemble the hooks and remove the screws using a screwdriver. Secondly, remove the headlight block of the Toyota Cs & s gently from the front. Now all you have to do is change the bulb and position the light unit in the other direction. More rarely, for some cars it is conceivable to remove the headlight unit from the outside. But it is relatively rare. In the event that this is what happens, with a screwdriver it will be necessary to remove the fasteners, remove the headlight unit quietly and replace the defective bulb.

How to change the bulb of a rear indicator on a Toyota Cs & s

There are also two different ways to access the turn signal bulb. It depends on the models, however, access will be either from inside or outside. Access from inside the trunk : Frequently access will be from inside the trunk. Regarding the headlight blocks, there are screws and fasteners. Take them off and take the piece out slowly. Thereafter you will only have to replace your defective bulb with a new one. And then repeat this operation in reverse. It also remains conceivable that access is from the outside or through the wheel arch. But it is much less frequent. In all cases, you need to bring your screwdriver and gently remove the entire light block in order to change the bulb. To reassemble, do the reverse manipulation.