Having working indicators remains mandatory. Remember, omitting a flashing light is punishable by 3 point on the permit as well as a fine . Even if some law enforcement officers are sometimes lenient on this point. It is therefore necessary to have indicators that work correctly. So we will find out here below how to change the bulb of a Volkswagen Golf 7 Sw turn signal, front and rear. It is also possible that the problem comes from a bad contact, nevertheless it is relatively exceptional.change-indicator-Volkswagen-Golf-7-Sw

Volkswagen Golf 7 Sw: things to know before changing your turn signal

First of all, it is important to properly select the model of your bulb! In order not to be mistaken, we advise you to go to a spare parts website or to your mechanic who can select them. Secondly, you will have to be careful to select the right color for the bulb. Then you will need a tools extremely basic but still essential. You will therefore mainly need a screwdriver for a Volkswagen Golf 7 Sw. A cruciform and torx kit and you are bound to be able to do it. Most of the time, the bulbs are bayonet . In order to take out the broken bulb, you must turn the bulb a quarter of a turn counterclockwise. To install the new bulb, you will need to turn it a quarter of a turn in the opposite direction.

How to change the bulb of a front indicator on a Volkswagen Golf 7 Sw

There are two main ways to access the flashing lights. It depends on the different models, however accessibility will be either from the outside or from the inside on a Volkswagen Golf 7 Sw. Access from inside the engine : First, you will have to open your hood. Then, you have to loosen a cover with a screwdriver (usually torx) in order to access the light unit. When the block is unclipped, remove it and it is possible to change your bulb. Wheel arch access : Check underneath the wheel to see if the clips are in this location. In case this is the case, you will need to remove the fasteners and remove the screws using a screwdriver. Secondly, remove the headlamp assembly from this Volkswagen Golf 7 Sw slowly from the front. Now all you have to do is change the bulb and position the block in the opposite direction. Exceptionally, on some cars it is possible to replace the light unit with the exterior. However, it is relatively rare. In the event that this is the case, with a screwdriver you will have to remove the fasteners, remove the light unit slowly and replace the faulty bulb.

How to change the bulb of a rear indicator on a Volkswagen Golf 7 Sw

There are also two main ways to access this turn signal bulb. It may depend on the models but accessibility will be either from the inside or from the outside. Access from inside the trunk : Almost every time accessibility will be from inside the trunk. For these light blocks there are screws and fixings. Remove them and remove the block slowly. Then you just have to replace your faulty bulb with the new one. Then repeat the same manipulation in reverse order. It is also possible that the accessibility could be from the outside or through the wheel arch. However, it is much less frequent. Whatever happens, you will need to take your screwdrivers and gently remove the headlight assembly assembly in order to change this bulb. To reassemble it, do the opposite.