
How a heater works on a Willys Jeep
In winter it is a definite asset on the road when you go to work. And when the latter does not work well it is easily noticed. In this case in order to know what is causing the malfunction, you need to know how it works on this Jeep Willys, at least in a simplified way. The heating uses heat from the engine block to heat the personalised tour, and very often the cooling device. In this way it duplicates. Also, the emission device, so that the hot air reaches us also has a double use. There is a ventilateur which emits hot air as soon as the vehicle is traveling at low speed or not at all, and it is the speed of the vehicle which will send hot air when you are traveling at high speed. It's pretty clever isn't it?
Recurring heating problems on a Willys Jeep
Broken thermostat
The idea is easy, in the event that the thermostat which allows the temperature to be adjusted does not really capture the temperature of the water circuit, the entire circuit is affected. Even if the thermostat on this Willys Jeep does not work properly, the heating will work normally. Because the natural heat of the engine block will increase over time, so the cooling circuit in the same way, even without a thermostat. Our only concern is that you cannot really set the temperature.
Air shutters blocked on the Willys Jeep
It is a dysfunction that happens quite often. These shutters, which allow you to direct the air or adjust the intensity, sometimes get blocked over time. To remedy this it is simple, remove the cover and look inside how it was done. Activate the mechanisms to see where it is blocking. Put a little WD 40 to lubricate and voila.
Defective fan on the Willys Jeep
You have now entered, the fan is only used at low speed and in neutral. If this heating system does not send too much heat at low speed and you still hear its noise, it means that your fan turns out to be very likely to run. Ordinarily, thanks to a fast pace the heating of this Jeep Willys must work. If it turns out that the fan really does not work it is better to replace it.
Blocked hoses
The signs are quite simple. As soon as your heating blows and does not create heat or very slightly, the malfunction probably comes from the hoses. They become blocked over time and no longer allow hot water to reach the heating of this Jeep Willys. In this case, remove the hoses or put new ones.
Air pocket in the Willys Jeep circuit
The syndrome will be similar to that of the durits. If air bubbles have gotten into the heart of the circuit, hot water has the same problems to access the heater radiator of the Jeep Willys. In this case, it is necessary to purge the circuit.
Conclusion
You now understand what could cause the malfunction. That said it may be that the problem comes from elsewhere, such as the air duct of this cluttered Jeep Willys, or even a defective tap, however it is still less common. You can write a comment in case this tutorial was useful to you. Good road !