
How a heater works on an Inca seat
In the middle of winter it is our best ally on the road when we go to work. And when the latter does not turn out well, we very much regret it. In this situation in order to know what the problem came from, we will have to know how it works on this seat inca, at least the basics. The heating uses engine heat to increase heat personalised tour, then in most cases the cooling system. So there is duplication. Also, the emission system, so that the heat reaches us also has a double use. There is a ventilateur which sends the heat as soon as the car is running at low speed or not, then it is the speed of the vehicle which will send the heat once you are traveling faster. It's pretty clever isn't it?
Recurring problems with heating on an Inca seat
Broken thermostat
The concept is elementary, in the case where the thermostat which regulates the temperature does not correctly capture the degree of heat of the water circuit, the latter is affected. Even if the thermostat of this seat inca still does not work well, the heating will operate normally. Because the heat coming from the engine will increase progressively, then the water circuit too, whether it is regulated or not. The only hassle is that you will have trouble setting the temperature.
Air shutters blocked on the seat inca
It is a concern that occurs quite frequently. These shutters, which allow you to direct the air or adjust the intensity, sometimes get blocked over time. To remedy this it is simple, remove the cover and look inside how it was done. Activate the mechanisms to see where it is blocking. Put a little WD 40 to lubricate and voila.
Faulty fan on seat inca
You have now entered, the fan is only used at low speed or at stop. If this heating system does not emit air at low speed and yet you nevertheless discern a sound, it is good that this fan will probably be screwed up. Normally, thanks to a brisk pace, the heating of this seat inca should work. Assuming that the fan does not work at all, it will have to be replaced.
Blocked hoses
The clues will be relatively simple. When your heating blows and does not generate hot air or very slightly, the problem must probably come from the hoses. These clog up over time and no longer allow hot water to access the heating of this seat inca. So, clean the hoses or install new ones.
Air pocket in the seat inca circuit
The syndrome will be the same as those of the hoses. If air pockets have become embedded in the circuit, hot water also has problems reaching the heating radiator of your seat inca. Then just purge the circuit.
Conclusion
You now understand what will cause the worry. However it happens that the concern comes from elsewhere, such as the air duct of this blocked Inca seat, or a broken valve, but it is still more rare. Leave us a comment if this tutorial has ever helped you. Good road !