Use of working flashing lights remains compulsory. Remember, omitting a flashing light is liable to 3 point on the permit as well as a fine . Although some police officers are occasionally complacent about this. It is therefore essential to have flashing lights in good working order. We will see below how to replace the bulb of a flashing light for a Volkswagen 1302, front and rear. It is also likely that the concern originated from a false contact, however it is relatively exceptional.
Volkswagen 1302: things to know before replacing its indicator
To start it is essential to properly buy the model of your bulb! So as not to be mistaken, it is advisable to go to a spare parts website or to your car repairer who can select them. In a second step you will have to think about selecting the right color for your bulb. Finally, you will need a tools extremely simple but still essential. You will therefore need a screwdriver for a Volkswagen 1302. A cruciform and torx kit and you will necessarily be able to get there. In most cases, the bulbs are at bayonet . In order to remove the faulty bulb you have to turn the bulb a quarter of a turn anticlockwise. In order to put the new bulb, it is necessary to actually rotate a quarter of a turn in the opposite direction.
How to change the bulb of a front indicator on a Volkswagen 1302
There are two different ways to access the flashing lights. It depends on the different models, however accessibility can be done either outside or inside for your Volkswagen 1302. Access from inside the engine : First of all, you will have to open your hood. Then, you will have to loosen the cover with the help of a screwdriver (frequently torx) in order to access the headlight unit. Once the unit is unclipped, remove it and you can replace your bulb. Wheel arch access : Look below the wheel to see if the fasteners are there. If this happens, it is necessary to disassemble the fasteners and remove the screws with a screwdriver. Then remove the headlight unit from the Volkswagen 1302 slowly from the front. All you have to do is replace your bulb and reattach the block the other way. Exceptionally, for some models it is likely to replace the headlight unit from the outside. But it is relatively rare. If this ever happens, with the help of a screwdriver you will have to remove the fixings, remove the headlight unit slowly and change your defective bulb.
How to change the bulb of a rear indicator on a Volkswagen 1302
There are also two different ways to access this turn signal bulb. It can depend on the ranges however the accessibility can be done either inside or outside. Access from inside the trunk : Most of the time accessibility can be done from the trunk. At the level of the light blocks, there are screws and fixings. Take them out and put the piece down, being careful. Finally you will simply have to replace your defective bulb with a new one. Then repeat the same manipulation in reverse. It is also likely that accessibility is done from the outside or through the wheel arch. But it is much less frequent. In all cases, it is necessary to use your screwdriver and gently remove the entire headlight unit in order to replace your bulb. To reassemble, take the opposite step.