Having turn signals that are in good condition is mandatory. Remember, not putting a flashing light is punishable by 3 point on your driver's license as well as a fine . Although some law enforcement officials are at times lenient on this point. It is therefore essential to have indicators that work properly. We will therefore find out below how to change the bulb of a flashing light for a seat exeo, at the front and rear. It is also possible that the malfunction comes from a short circuit, however it is relatively rare.
seat exeo: things to know before changing your turn signal
First of all it is wiser to buy the model of your bulb! In order not to be mistaken, we advise you to go to a spare parts site or to a mechanic who knows how to order them for you. Secondly, you will have to think about selecting the right color for the bulb. Finally, you will need to use a tools very simple but still necessary. You will therefore need a screwdriver for a seat exeo. A game of cruciform and torx and you will be able to do it. Most of the time, the bulbs are at bayonet . In order to remove the damaged bulb, you must turn the bulb a quarter of a turn to the left. To put the new bulb, it is necessary to turn it a quarter of a turn in the other direction.
How to change the bulb of a front indicator on a seat exeo
There are two different ways to access the turn signals. Indeed, it depends on the models, however access will be either from the outside or from the inside on your seat exeo. Access from inside the engine : To start, you will have to open your hood. Then, you will have to unscrew the cover with a screwdriver (usually torx) to access the light block. Once the block is unscrewed, remove it and it is possible to change this bulb. Wheel arch access : Check below the wheel to see if the clips are there. If this happens, it is necessary to remove the fasteners and remove the screws with the help of your screwdriver. Second, remove the light unit from your seat exeo slowly from the front. It is now enough to change the bulb and position the block of lights following the reverse approach. Exceptionally, on some models it is possible to remove the light block from the outside. However, it is relatively rare. If ever this happens, with a screwdriver you will need to remove the fasteners, gently remove the light block and replace the failed bulb.
How to change the bulb of a rear indicator on a seat exeo
There are also two different ways to access this turn signal bulb. It depends on the ranges, however access will be either from inside or outside. Access from inside the trunk : Almost every time access will be from the trunk. At the light blocks, there are screws and fasteners. Take them out and remove the part, being careful. Finally you will just have to replace this faulty bulb with the new one. Then repeat this operation in reverse. It is also possible that access can be from the outside or under the wheel arch. However, it is much rarer. In all cases, it is necessary to bring your screwdrivers and remove, paying careful attention to the entire light unit in order to change the bulb. To reassemble, perform the opposite manipulation.