Your FAP indicator light is on and you do not know what caused the problem. The FAP mainly exists on vehicles Diesel, even though they are now found on petrol vehicles. Before starting repairs on this Seat Ginebra, it is important to know where this concern comes from. How does a particle filter work? Why does the indicator light go off? What are the most regular concerns? In this article, we will give a point by point overview. 
What is an FAP on your Seat Ginebra
As its designation presages, it is used to purify microscopic molecules toxiques of your engine. These molecules are so small that they easily fit through your body. It is also Peugeot who invented this particle filter. The catalyst is used to restrict the quantity of molecules emitted by the vehicle, while the particle filter collects the rest. It is therefore essential to have a FAP in good condition if you no longer want this Seat Ginebra to contaminate the air you inhale.
Why the FAP indicator light on your Seat Ginebra
The FAP of your Seat Ginebra is clogged
Here is the most common problem. No worries, a particle filter becomes blocked over time. Molecules collect and block the flow of your exhaust gases. A priori, the particle filter on this Seat Ginebra must purge on its own and destroy this waste. That said, if it is too old it must be changed.
An electronic problem
The concern with the LEDs is that you are never sure of the problem. In practice, it sometimes happens that an indicator light comes on while this Seat Ginebra works without worries. This particle filter has several electronic sounders which send the warning to the indicator. When these sensors do not work well while the particle filter is doing well, it is likely that the indicator light is on.
What to do if the FAP indicator on your Seat Ginebra lights up?
First of all, it's completely illegal to remove the fap on your Seat Ginebra! It is an offense. You can check the probes to see if they work perfectly. If these work perfectly, the problem comes from the FAP. If it was dirty, you can unclog it by driving in the towers for about ten minutes. Do not climb too much in the towers, the process may damage the vehicle. We advise you to drive to 3000 rpm. The temperature of the vehicle will in this way burn the stored soot, and therefore clean your particle filter. If this method is still not suitable, it must be replaced.
Conclusion:
The damaged particle filter should pollute as well as reduce the power of the vehicle. It is therefore essential to have it changed. Write a comment in case our ticket served you. Good walk !