Your FAP warning light goes off and you don't know what caused the problem. FAP is mainly found on cars Diesel, even if we find them more and more on gasoline cars. Before you get into repairs On this Toyota Camry 2, it is essential to know where this concern comes from. How does a FAP work? Why is the light on? What can be the most common problems? In this article, we will go over the question. warning-fap-Toyota-Camry-2

What is a FAP used for on your Toyota Camry 2

As its name presages, its role is to purify microscopic molecules harmful of the engine block. The molecules are so small that they can easily enter your body. For information, it's Peugeot who created this FAP. Your catalyst is used to reduce the quantity of molecules produced by the engine, while the particle filter collects the remains. It is therefore essential to have a particle filter in good working condition if you no longer want this Toyota Camry 2 to contaminate the air you inhale.

Why the FAP indicator light on your Toyota Camry 2

The FAP of your Toyota Camry 2 is clogged

Here is the most common problem. No wonder, a particle filter becomes blocked as time goes by. Molecules form clusters and block the flow of these exhaust gases. Normally, the particulate filter of this Toyota Camry 2 can be cleaned by itself and therefore eliminate this waste. On the other hand, if this one is particularly old you will have to replace it with a new one.

An electronic problem

The problem with indicator lights is that you are by no means certain of the problem. Indeed, it frequently appears that an indicator light flickers while this Toyota Camry 2 works without worries. The particulate filter has several electronic sensors which send a warning towards the dashboard. If these probes do not work well when your particle filter is fine, it is conceivable that the indicator is on.

What to do if the FAP indicator on your Toyota Camry 2 lights up?

At first, it is absolutely forbidden to remove the particle filter on your vehicle! Indeed, it is a crime. You will be able to check the sounders to see if they are working properly. If these work properly, the problem comes from the Particulate filter. If it was dirty, you can unclog it by rolling in the towers for 10 minutes. Do not climb too much in the towers, this can damage the engine. We advise you to drive to 3000 rpm. The engine temperature should roast the stored soot in this way and clean your particulate filter. If ever such a procedure does not work at all, it is necessary to have it changed.

Conclusion:

A damaged particle filter can pollute but also cause loss of power. It is therefore essential to have it changed. Leave us a comment in case this article helped you. Enjoy the road!