Your DPF warning light goes off and you don't know what the problem is. The DPF is found particularly for cars Diesel, although they will now be found for petrol cars. Before launching into repairs for the Toyota Camry 5, it remains essential to know where the concern came from. How does a particulate filter work? Why does the indicator light come on? What are the most regular problems? In this article, we will do a point-by-point guide. warning-fap-Toyota-Camry-5

What is a FAP used for on your Toyota Camry 5

As its designation indicates, its role is to purify microscopic particles harmful of your engine block. These molecules are so tiny that they can easily enter our body. For information, it is Peugeot who created the particulate filter. The catalyst serves to reduce the dose of particulates generated from the engine, and the particulate filter collects the waste. It is therefore necessary to have a DPF in good condition in case you do not want the Toyota Camry 5 to pollute the environment.

Why the FAP indicator light on your Toyota Camry 5

The FAP of your Toyota Camry 5 is clogged

This is the most common problem. No worries, your particulate filter gets clogged over time. Particles form clusters and hinder the evacuation of your exhaust gases. Normally, the particulate filter of the Toyota Camry 5 can be cleaned by itself and thus eliminate this waste. On the other hand, if it is too old it is necessary to change it.

An electronic problem

The concern with the indicator lights is that you are by no means sure there is a problem. In fact, it sometimes happens that an indicator light flickers while the Toyota Camry 5 is working perfectly. Your particle filter has a few electronic sensors which send a signal to your dashboard. If your sounders have a problem while your particulate filter is fine, the warning light is likely to go off.

What to do if the FAP indicator on your Toyota Camry 5 lights up?

Above all, it is completely forbidden to remove the fap on your vehicle! Indeed, it is a crime. You will be able to check the probes to be able to see if they are working well. If these work perfectly, the concern comes from the DPF. If it was filthy, it can be cleaned by driving at high speed for about ten minutes. Without exaggerating, this can damage the engine. We advise you to drive at 3000 rpm. The temperature of the engine block can in this way burn the stored soot, and therefore clean your particulate filter. In the event that such a scheme does not work, it must be changed.

Conclusion:

A fap in poor condition can pollute but also lose power. It is therefore essential to take care of it. Write a comment if this file has helped you. Good walk !