The particle filter indicator light comes on and you do not know what caused the malfunction. The particle filter is mainly found in cars Diesel, although they will now be found in petrol cars. Before launching into repairs In the Toyota Yaris 3, it remains essential to understand what is causing the problem. What is a particle filter used for? Why is the light on? What are the most common problems? In this text, we will go around the subject. indicator-fap-Toyota-Yaris-3

What is a FAP used for on your Toyota Yaris 3

As its designation suggests, it is used to filter microscopic particles harmful of the vehicle. These molecules are so small that they easily fit through your body. For information, it's Peugeot who developed the particulate filter. Your catalyst is used to limit the dose of particles produced by the engine, and the particle filter collects the remains. It is therefore essential to have a particulate filter in good condition in case you do not want the Toyota Yaris 3 to pollute the environment.

Why the FAP indicator light on your Toyota Yaris 3

The FAP of your Toyota Yaris 3 is clogged

It is the most frequent dysfunction. No worries, the particle filter becomes dirty as time goes by. These particles pile up and then hinder the evacuation of your exhaust gases. In general, the particle filter in the Toyota Yaris 3 can be cleaned on its own and thus flush out clumps. However, if it is too old it will have to be changed.

An electronic problem

The concern about the LEDs is that you are by no means certain to have a malfunction. Undeniably, it sometimes appears that an indicator light comes on while the Toyota Yaris 3 is working perfectly. Your particle filter has several electronic probes that send a warning to your dashboard. If your sensors have a malfunction while the particle filter is fine, it is conceivable that the indicator light will come on.

What to do if the FAP indicator light on your Toyota Yaris 3 lights up?

At first, it is absolutely illegal to remove the fap on your Toyota Yaris 3! Indeed, it is a crime. You will need to check the sounders to see if they are working properly. If they themselves work well, the problem comes from the FAP. If it was dirty, you will be able to repair it by driving in the towers for about 10 to 15 minutes. Do not accelerate too much either, the process could damage the vehicle. We advise you to drive at 3000 revolutions minutes. The heat from the engine should therefore burn off the encrusted dirt, and clean your particle filter. If this manipulation is not suitable, it must be changed.

Conclusion:

The particle filter in poor condition can pollute and make you lose power. It is therefore important to replace it. Post a comment in case our article helped you. Enjoy the road!