When this injection system falls into breakdown it can be extremely unpleasant. Often, it is noticed by fuel fumes or a loss of acceleration. Is the problem with the injectors? of the injection pump? We will answer these questions to identify this problem as well as possible. But at first, it can be essential to understand the principle of an injection system .
Injection system on a Toyota Mr 3: how it works
In order to function properly, the engine block of your Toyota Mr 3 requires a mixture of air and fuel. It is injector which gives the possibility of propelling this mixture in the engine block. If the injector has a problem, your Toyota Mr 3 may no longer start. An injection system consists of a pumps and injectors , sometimes joined by a common rail . The very first injection engine block was developed in 1893 by Rodolphe Diesel himself.
Injector problem on a Toyota Mr 3: reasons and consequences
Lack of power or acceleration
If your Toyota Mr 3 loses power, or has power holes, it is certainly due to the injector. It can still be considered dirty because of the deposits. It is for this reason that it is wiser to use a quality fuel. Make a descaling will be much less expensive than having this device replaced.
Fuel smell
When fumes of fuel are felt, it certainly comes from a fuite . If this is the case, avoid driving your Toyota Mr 3. Fuel leaks are infrequent, however quite dangerous. So go to the mechanic, he'll tell you what to do. If it is ever a problem with the seal, you will be able to attempt a repair. Hoping that the injector is not clearly out of service.
Engine runs but does not start
The problem does not automatically come from the injector. The reasons will be many. If, however, you are convinced that the injector is the cause, it is certainly because of the injection pump . The latter may be seized or hold a leak. You should know that replacing the injection pump in your Toyota Mr 3 is quite expensive, it is therefore essential to properly understand the problem.
Maintain the injection of your Toyota Mr 3
These are now some solutions to avoid injection malfunctions.
- Buy one fuel of a very high quality.
- Drive about 15 minutes at 3000 revolutions per minute Once every two or three months. The heat generated by the engine block will unclog the constituents, and the injection in passing.
- Drain fairly regularly.
You now know what the malfunctions are related to the injection of your Toyota Mr 3 and certain techniques to work around them. In case this problem does not go away, you can go to a specialist, quite simply because it is a really important component of the engine block. Leave a comment if this injection post was helpful. Enjoy the road!