La power loss on the Jeep Commander is a fairly common syndrome. However, the causes can be many. What can cause a drop in power? Is it the engine block that hangs due to dysfunction ? Is it simply a malfunction of sensor ? We will answer all of these questions in this file, by listing the very usual causes. If your Jeep Commander works properly after you restart the engine, it is most likely a malfunction electronic . If, on the other hand, the malfunction is causing resistance, it is useful to look for the source. Because this will probably save you from having to replace various parts at your mechanic's.
Jeep Commander Power Loss: The Most Common Causes
Let's see here what will be the reasons for your malfunction and how to remedy it.
Jeep Commander: flowmeter malfunction.
Le lack of power of your Jeep Commander may be due to a malfunction of the air flow meter. This part of the engine block has the role of measuring the air volume in the engine block, in order to optimize the capacities of the engine block. In the event that this probe has a malfunction, the injectors will not give the correct dose of fuel. Consequence: a fall in power.
Air compression concern
Whether it is a compressor or a turbo compressor, the malfunction will be quite similar. the compressor has the role of propelling the air inside the engine block of your Jeep Commander. If the latter is damaged, the amount of air will sometimes decrease. As an engine needs a perfect mixture of air and fuel to be able to function, its capacities can be reduced. Dig a few minutes to determine the malfunction, since changing it is quite expensive.
Loss of power: an injection malfunction?
In the event that this Jeep Commander has power losses or even jerks, it happens that the injection is in question. We invite you to look at our little file on injector failures to better understand the problem. Do not wait too long to deal with this malfunction, its sequelae can be very important on your engine block.
The particle filter of your Jeep Commander is clogged
The malfunction can come from various reasons. In order to limit the impact on the environment, vehicles now have safety systems. In the event that the FAP is defective, it is possible that your car will go into safety and prevent strong acceleration. The second impact is physical. The blocked fap prevents the engine block of your Jeep Commander from ventilating properly. The consequence is therefore a lack of performance.
Lack of acceleration: an electronic fault
However, this is a fairly common reason. It is possible that your Jeep Commander's sensors, or else electronic chips, are malfunctioning. The signal sent to your on-board computer means that it can go into safety mode. This is to avoid engine breakage or excess pollution. So, if you want to remedy this malfunction, examine the sensor connections. This kind of malfunction is usually accompanied by a witness on your dashboard. Otherwise, go to a mechanic, the diagnosis will be easier to perform. Be careful and have a good ride!