Behind these buttons there are rather ingenious mechanisms. Ingenious, however quite often defective! Because it is a concern that we have all known, for a Jeep Wagoneer or another car. But before changing the mechanism, it will be necessary to properly understand where the malfunction came from. Contact malfunction? Gears stuck? We will try to answer your questions in this article.window-lift-problem-Jeep-Wagoneer

Jeep Wagoneer: a window goes down but does not go up, or vice versa

Before changing the component, let's quickly study how it works. When you press, or raise the button on your window, there are two switches in practice . The electrical signal flows just when it is activated. It is in fact likely that the concern came from a false contact. Remove the block using a flat screwdriver, then observe the cables at their beginning and at their end. If the malfunction is not due to an electrical fault, then the engine of the window regulator in your Jeep Wagoneer is the cause. Gears may also be worn. It is possible to try to resolve the problem, but usually it will be necessary to replace the entire window regulator.

Jeep Wagoneer: One window doesn't work at all

It is rather exceptional that the malfunction comes from the switch, because it would be necessary that the two connections or cables are faulty. However, you can check if you want to be sure. In this situation, the malfunction could come from the window regulator mechanics of the Jeep Wagoneer. The latter may be from engine window lifter, or a faulty gear. Remove the door covers to check inside. Operate the window to see if the engine is running, and try to understand the causes of the malfunction. In case gears get stuck you can clean and grease them. In the event that nothing happens, you will probably have to change the entire window regulator mechanism.

Jeep Wagoneer: Electric window blocked

A window of this Jeep Wagoneer is stuck. You try to reassemble it by pressing the button or by hand, nothing happens it is stuck. This malfunction can come from the motor of your window regulator, but usually it will be possible to wind it by hand. It is in fact much more admissible that the window is out of its rail . By offsetting, as soon as you mount the window, it locks on one of the sides. In this case, there is no point in forcing. You will have to open the door and check what is blocking it. If the window guides are damaged, you should probably replace them.

Conclusion:

Simply put, a window malfunction on a Jeep Wagoneer can come from an electrical malfunction, from the mechanism of your window regulator, or from the rails that guide it. We invite you to leave a comment if your concern is not mentioned above. Hoping this guide has served you well, enjoy the ride!