Beneath these switches are some pretty ingenious mechanisms. Ingenious, however quite often defective! Because this remains a problem that we have all seen, on a Hyundai Ix55 or another car. But before replacing the system, it will be necessary to properly understand where the malfunction came from. A malfunction of false contact? Gears stuck? We will try to answer all of the questions with this article.problem-WINDOW-Hyundai-Ix55

Hyundai Ix55: a window goes down but does not go up, or vice versa

Before replacing the part, let's quickly study how it works. When you press, or raise the button on your window, there are two switches in practice . The electrical signal passes just when it is activated. It is therefore conceivable that the problem comes from an electrical fault. Remove the block with a flat screwdriver, then observe the electrical wiring at its beginning and at its end. If the malfunction does not come from an electrical fault, in this situation it is the window lift motor of your Hyundai Ix55 that is HS. It also happens that gears are damaged. You can try to correct the problem, but often you will have to replace the entire window regulator.

Hyundai Ix55: One window doesn't work at all

It is rare that the malfunction comes from the switch, since two switches or cables would have to be defective. However, you can check if you want to be convinced. Therefore, the malfunction will come from the window regulator mechanism of the Hyundai Ix55. It happens that the latter comes from engine window lifter, or a faulty gear. Remove the door covers to see inside. Operate the window to be able to discern if the engine is running, and try to grasp the source of the malfunction. When gears jam, do not hesitate to dust and grease them. When nothing happens, you will most likely need to replace the entire window regulator system.

Hyundai Ix55: Electric window blocked

A window of the Hyundai Ix55 is blocked. You try to raise it by pressing the button or by hand, nothing to do it is stuck. This malfunction can come from the motor of your window regulator, but often it will be possible to have it assembled by hand. It is therefore more likely that your window has come out of its rail . When moving, when you mount your window, the latter abuts on one of the sides. In this situation, do not force force. You're going to have to open the door and go see what's stuck in it. If the glass guides fail, they will certainly have to be replaced.

Conclusion:

Basically, a window malfunction on a Hyundai Ix55 could be the result of an electrical malfunction, of the mechanism of your window regulator, or of the rails that hold it. We invite you to post a comment if your problem is not mentioned in our text. Hope this guide has helped you, have a good ride!