Under these switches you can find rather ingenious systems. Ingenious, however quite often defective! Because this is a problem that we have all seen before, for a hyundai santa fe or another automobile. However before replacing the system, it will be necessary to understand correctly what the problem comes from. An electrical fault problem? Gears stuck? We will try to answer all of your questions with this article.problem-window-lift-hyundai-santa-fe

hyundai santa fe: a window goes down but does not go up, or vice versa

Before replacing the component, let's just see how this device works. When you push in or lift the switch from your window, you can find two switches in reality . The electrical signal only flows when you operate it. It is therefore conceivable that the problem comes from an electrical fault. Remove the block using a flat screwdriver, then check the electrical wiring when they leave when they arrive. If the problem does not arise from a false contact, in this case it is the window regulator motor of your hyundai santa fe that does not work. It also happens that gears happen to be worn. Do not hesitate to try to correct the problem, but in general you will have to change the complete window regulator.

hyundai santa fe: One window doesn't work at all

It is rare that the problem comes from the switch, since it would be necessary that two switches or cables are defective. You can however control if you want to be sure. In this case, the problem will come from the mechanism of the window regulator of the hyundai santa fe. It happens that the latter comes from engine window regulator, or a damaged gear. Remove the door trim to see inside. Operate the window to see if the engine is running, and try to understand the source of the problem. If any gears jam, do not hesitate to clean and grease them. If nothing happens, it is certainly necessary to replace the entire window regulator system.

hyundai santa fe: Electric window blocked

A window in your hyundai santa fe is stuck. You try to reassemble it by pressing the switch or else manually, nothing happens it is blocked. This problem could come from the motor of your window regulator, but in general it will be possible to reassemble it manually. It is therefore more plausible that your window has come out of its rail . By offsetting, when you mount your window, it hangs on one side. In these cases, you should not force force. It is necessary to open the door and check what gets stuck in it. If the window guides ever prove to be broken, you should definitely replace them.

Conclusion:

To summarize, a glass problem on your hyundai santa fe could be the result of a problem related to a false contact, of the mechanism of your window regulator, or of the rails which hold it. You can leave us a comment if your problem is not mentioned above. Hoping this guide has served you well, enjoy the ride!