Behind these switches are some pretty ingenious mechanisms. Ingenious, but quite often defective! Because this is a problem that we have all had, for a Jeep Commander or any car. But before replacing your mechanism, it is necessary to know well where the problem came from. A problem with false contact? Gears seized? We will try to answer your questions so this tutorial.window-lift-problem-Jeep-Commander

Jeep Commander: a window goes down but does not go up, or vice versa

Before replacing the element, let's quickly understand how this device works. When you press, or raise the button on your window, there are two switches in practice . The electrical connection only goes through when activated. It is therefore possible that the problem is caused by an electrical fault. Remove the part using a flat screwdriver, and observe the cables at their beginning and at their end. If the problem does not come from a bad electrical connection, in this case it is the window regulator motor of your Jeep Commander that is at fault. Gears may also be damaged. It is possible to try to repair the problem, but often it is necessary to replace the whole window regulator.

Jeep Commander: One window does not work at all

It is rare that the problem comes from the switch, since it would be necessary that the two connections or cables are defective at the same time. However, you can check if you want to be sure. Therefore, the problem will certainly come from the window regulator mechanism of the Jeep Commander. It may come from engine window regulator, or a damaged gear. Remove the door covers to look inside. Activate the window to see if the engine is running, and try to understand the source of the problem. If any gears jam, it is possible to clean and lubricate them. If nothing ever happens, it is probably necessary to replace the entire window regulator.

Jeep Commander: Electric window blocked

A window of this Jeep Commander is stuck. You try to raise it by pressing the button or by hand, nothing to do it is stuck. This problem can come from the motor of your window regulator, but often it will be possible to have it assembled by hand. It is therefore much more admissible that your window has come out of its rail . When moving, when you mount your window, the window hangs on one side. In this case, there is no point in forcing. You will have to open the door and check what is blocking inside. If the glass guides fail, you will probably have to replace them.

Conclusion:

To put it simply, a glass problem on your Jeep Commander could come from a problem related to a false contact, of the system of your window regulator, or of the rails which hold it. You can write a comment if your problem does not appear above. Hope this article has helped, enjoy the ride!