Behind these switches are relatively ingenious mechanisms. Ingenious, however quite often non-functional! Because this remains a problem that we have all had, on a Jeep Ford or another car. Before replacing the mechanism, however, it will be necessary to understand what caused the problem. A problem with false contact? Gears stuck? We will try to answer all of your questions below.problem-window-lift-Jeep-Ford

Jeep Ford: a window goes down but does not go up, or vice versa

Before replacing the part, let's just look at how it works. When you push in or raise the switch on your window, there are two switches in practice . The electrical signal only flows when activated. It is therefore conceivable that the problem stems from an electrical fault. Remove the block with a flat screwdriver, then observe the electrical wiring at its beginning and at its end. If the problem does not come from an electrical fault, in this case it is the window regulator motor of your Jeep Ford that is at fault. It is also possible that gears are found to be in poor condition. You can try to solve the problem, but often you have to change the entire window regulator.

Jeep Ford: One window doesn't work at all

It is rare that the problem comes from the switch, since it would be necessary that the two switches or cables are faulty. You can still watch if you want to be sure. Therefore, the problem could come from the window regulator mechanics of your Jeep Ford. It is possible that it comes from engine window lifter, or a faulty gear. Remove the door trim to look inside. Open the window to see if the engine is running, and try to pinpoint the source of the problem. If any gears jam, it is possible to dust and lubricate them. If nothing ever happens, you will certainly have to change the entire window regulator.

Jeep Ford: Electric window blocked

A window of this Jeep Ford is blocked. You try to reassemble it by pressing the switch or manually, nothing to do it remains blocked. This problem can come from the motor of your window regulator, but often it will be possible to wind it manually. It is therefore more likely that the glass has come out of its rail . By decentering, when you mount the window, it will come up against the rail. In these cases, you should not force force. You will have to open the door and go see what is blocking it. If the glass guides fail, they will certainly have to be replaced.

Conclusion:

To summarize, a glass problem on a Jeep Ford can result from an electrical problem, from the system of your window regulator, or from the rails which guide it. We invite you to write a comment if your problem is not mentioned in our text. Hope this guide has served you well, see you soon!