Behind these buttons we can find rather ingenious systems. Ingenious, yet sometimes failing! Because it is a malfunction that we have all had before, for a Seat 600 or any car. However, before changing your device, you will have to properly understand where the problem came from. An electrical fault problem? Are the gears stuck? We will try to answer all of your questions in this article.
Seat 600: a window goes down but does not go up, or vice versa
Before changing the component, let's quickly see how this device works. When you press or lift the switch on your window, there are two switches in the facts . The electrical signal passes just when you activate it. It is therefore possible that the malfunction comes from an electrical fault. Remove the block with a flat screwdriver, then inspect the cables at their beginning and end. If the problem is not a bad electrical connection, in this situation it is the window regulator motor of your Seat 600 that does not work. It is also possible that gears are worn. You can try to correct the malfunction, but usually you will need to replace the entire window regulator.
Seat 600: A single window does not work at all
It is rather unusual that the problem is with the switch, since both connections or cables would have to be faulty. You can still check if you want to be sure. In this case, the problem will come from the mechanism of the window regulator of the Seat 600. It is possible that this comes from the engine window regulator, or a damaged gear. Remove the door covers to examine the interior. Activate the window to see if the engine is running, and try to understand the source of the problem. In the event that gears jam, you can dust and grease them. If nothing happens, it will probably be necessary to change the entire window regulator system.
Seat 600: Electric window blocked
A window of the Seat 600 is blocked. You try to raise it by operating the switch or by hand, nothing happens it is blocked. This problem can come from the motor of the window regulator, but usually it will be conceivable to raise it by hand. It is therefore more likely that the window has come out of its rail . By shifting, as soon as you mount the window, it hits the rail. In this case, there is no point in forcing. You will have to clear the door and check what is blocking in it. If the window guides prove to be faulty, you should probably change them.
Conclusion:
To put it simply, a problem with the glass on your Seat 600 could come from an electrical problem, the window regulator mechanism, or the rails that hold it. Do not hesitate to write a comment if your dysfunction is not mentioned above. Hope this article has helped you, be careful!