Under these little buttons you can find relatively ingenious mechanisms. Ingenious, but quite often failing! Because it remains a malfunction that we have all had, for a Seat Fura or any automobile. Before changing the system, however, it is necessary to understand properly what the problem is about. An electrical fault concern? Gears stuck? We will try to answer all the questions here.window-lift-problem-Seat-Fura

Seat Fura: a window goes down but does not go up, or vice versa

Before changing the part, let's quickly study how it works. When you press, or raise the switch of the famous window, there are two switches in practice . The electrical signal only passes when you activate it. It is thus conceivable that the dysfunction results from a false contact. Remove the block using a flat screwdriver, and check the electrical wiring at their beginning and at their end. If the problem never comes from a bad electrical connection, then the window regulator motor in your Seat Fura will not work. It is also possible that the gears are in poor condition. It is possible to try to resolve the malfunction, but often it is necessary to replace the complete window regulator.

Seat Fura: One window doesn't work at all

It is rare that the concern comes from the switch, since it would be necessary that the two connections or cables are defective at the same time. You can however check if you want to be sure. In this situation, the concern will come from the window regulator mechanism of your Seat Fura. It is possible that it comes from engine window lifter, or a faulty gear. Remove the door trim to see inside. Activate the window to see if the engine is running, and try to understand the causes of the problem. If any gears jam, it is possible to clean and lubricate them. If nothing happens, you will probably have to replace the entire window mechanism.

Seat Fura: Electric window blocked

A window of the Seat Fura is stuck. You try to reassemble it by pressing the switch or by hand, nothing happens it is blocked. This concern can come from the window regulator motor, but often it will be possible to reassemble it by hand. This makes it much more possible for the glass to come out of its rail . By off-center, when you mount the window, the window hangs on the rail. In this case, there is no point in forcing. You have to clear the door and check what gets stuck inside. If the glass guides ever prove to be damaged, you will probably have to change them.

Conclusion:

Basically, a glass problem on your Seat Fura could come from an electric problem, the window regulator mechanism, or the rails which hold it. You can leave a comment if your malfunction is not mentioned above. Hope this text has helped you, be careful!