Behind these little buttons are relatively ingenious mechanisms. Ingenious, however from time to time non-functional! Because it is a problem that we have all known, on a Toyota Corona or any car. Before replacing the system, however, it is necessary to properly know where the problem is coming from. An electrical fault problem? Gears stuck? We will try to answer your questions below.window-lift-problem-Toyota-Corona

Toyota Corona: a window goes down but does not go up, or vice versa

Before replacing the part, let's quickly see how this device works. When you push or lift the button on the famous window, you can find two switches in practice . The electrical signal only passes when activated. It is therefore likely that the problem comes from an electrical fault. Remove the part using a flat screwdriver, then check the cables at their beginning and at their end. If the problem must not come from an electrical fault, then the window regulator motor in your Toyota Corona is HS. It is also possible that gears are found to be worn. You can try to troubleshoot the problem, but usually you need to replace the entire window regulator.

Toyota Corona: One window doesn't work at all

It is not very frequent that the problem comes from the switch, because it would be necessary that two switches or cables are defective at the same time. However, you can check if you want to be sure. In this case, the problem could come from the window regulator mechanics of your Toyota Corona. It is possible that it comes from engine window regulator, or a damaged gear. Remove the door trim to look inside. Activate the window to discern if the engine is running, and try to understand the source of the problem. If any gears jam, do not hesitate to clean and lubricate them. If nothing happens, you probably have to change the entire window regulator mechanism.

Toyota Corona: Electric window blocked

A Toyota Corona window is stuck. You try to reassemble it by pressing the button or manually, nothing happens it remains blocked. This problem could come from the motor of your window regulator, but in general it will be possible to reassemble it manually. It is therefore much more likely that your window has come out of its rail . By moving, as soon as you mount your window, the latter abuts on one side. In these cases, there is no point in forcing. It is necessary to open the door and look at what is stuck inside. If the glass guides fail, you will probably have to replace them.

Conclusion:

Basically, a window problem on your Toyota Corona can be the result of an electrical problem, the mechanism of your window regulator, or the rails that hold it. Do not hesitate to post a comment if your problem is not mentioned in our text. Hoping that this file has served you something, good ride!