
How a heater works on a Hyundai I-mode
When it is cold it is our best ally on the road when we go to work. When it does not work we notice it intensely. So to understand what the problem is, you have to understand how it works on your Hyundai I-mode, at least the basics. The heating uses the temperature of the engine block to increase the heat of the personalised tour, and in most cases of the cooling device. Therefore it is a two in one. Also, the emission device, so that the hot air reaches the cabin also has a double use. It's the ventilateur which emits hot air when the vehicle is traveling at low speed or not, and it is the speed of your automobile that allows hot air to be sent when you are traveling at high speed. Pretty well thought out right?
Recurring heating problems on a Hyundai I-mode
Broken thermostat
The idea is elementary, if the thermostat which regulates the heat does not really measure the degree of heat of the cooling circuit, the whole circuit is impacted. Even if the thermostat of your Hyundai I-mode still does not turn well, the heating will still work. Because the temperature produced by the engine block will increase over time, so will the cooling system the same whether the thermostat works or not. The only hassle is that you will have trouble controlling the air temperature.
Air shutters blocked on the Hyundai I-mode
This is a problem that occurs quite frequently. These shutters, which allow you to direct the air or adjust the intensity, sometimes get blocked over time. To remedy this it is simple, remove the cover and look inside how it was done. Activate the mechanisms to see where it is blocking. Put a little WD 40 to lubricate and voila.
Faulty fan on Hyundai I-mode
As you can imagine, the fan is only used at low speed or when stopped. If your heating system never sends out heat at low speed at all and you nevertheless discern its noise, that means that your fan is probably running out. Generally, with a higher speed, the heating of your Hyundai I-mode should turn. Supposing that the fan really does not rotate, it will have to be changed.
Blocked hoses
Its clues are relatively obvious. If your heating blows but does not generate little or no hot air, the problem must probably come from the hoses. These clog up over time and no longer allow hot water to heat your Hyundai I-mode. Therefore, wash the hoses or replace them with new ones.
Air pocket in the Hyundai I-mode circuit
The syndrome is found to be similar to that of the durits. If ever air bubbles are inserted within the circuit, hot water will also have problems reaching the radiator of the heating of this Hyundai I-mode. Therefore, it is only necessary to purge the circuit.
Conclusion
You now understand what may be causing the problem. By cons it may happen that the problem comes from another place, such as the air duct of your Hyundai I-mode clogged, or a defective valve, but it is still less common. Do not hesitate to leave a comment if this text has helped you. Enjoy the road!