heating-problem-hyundai-i10

How a heater works on a hyundai i10

When it's cold it is essential on the way to work. When it doesn't work well we quickly miss it. Therefore in order to find out what the problem is, you will have to know how it works on your hyundai i10, at least in a simplified way. The heating uses the heat from the engine block to raise the temperature of the personalised tour, then in most cases the cooling system. So it is duplicative. In addition, the emission system, so that the heat reaches us has a double system. There is a ventilateur which emits heat when the car is running at low speed or at walking pace, then it is the speed of the car which allows the heat to be sent when you are going faster. Well designed, right?

Recurring problems with a heater on a hyundai i10

Broken thermostat

The idea is simple, supposing that the thermostat which allows to regulate the temperature does not understand well the degree of heat of the water in the circuit, the latter is affected. Even if the thermostat of your hyundai i10 no longer works well, the heating will still work. Because the heat coming from the engine block will increase gradually, and the water circuit too, whether it is regulated or not. The only concern is that you will have difficulty setting the heat emitted.

Air flaps blocked on the hyundai i10

It's a concern that happens quite often. These shutters, which allow you to direct the air or adjust the intensity, sometimes get blocked over time. To remedy this it is simple, remove the cover and look inside how it was done. Activate the mechanisms to see where it is blocking. Put a little WD 40 to lubricate and voila.

Defective fan on the Hyundai i10

As you will understand, the fan is only used at low speed and the engine is off. If the heater is not sending heat at all at low speed and yet you can still hear noise, that fan is definitely going to run out. As a general rule, with a higher speed the heating of your hyundai i10 will turn. If ever the fan does not turn, it will have to be changed.

Blocked hoses

The symptoms are relatively straightforward. When your heater works and does not create heat or very slightly, the problem is probably from the hoses. The more time passes, these become blocked and do not allow hot water to reach the heating of your hyundai i10. In this situation, wash the hoses or install new ones.

Air pocket in the circuit of the hyundai i10

The symptom is similar to those of hoses. If air bubbles are stored in the circuit, high temperature water similarly has problems reaching the heating radiator of this hyundai i10. In this situation, it will suffice to purge the circuit.

Conclusion

You now understand where the concern might come from. Having said that, it happens that the reason comes from another place, such as the air duct of your cluttered hyundai i10, or a defective tap, but this is still less frequent. Do not hesitate to leave a comment if this post has been useful to you. Good road !