
How a heater works on a Hyundai I30 (3rd Generation) N
In the middle of winter it is essential on the way to go to work. And when the latter does not turn out well we easily regret it. So in order to know what the problem is coming from, you will need to understand how it works on your Hyundai I30 (3rd Generation) N, at least the basics. The heating uses the engine block temperature to be able to heat the heat up personalised tour, then very often from the cooling device. In this way this system has several functions. In addition, the emission device, so that the hot air reaches us also presents a duplication. It's the ventilateur which sends hot air when the vehicle is running at low speed or not at all, then it is the speed of your automobile which will send hot air once you are driving at high speed. Pretty well thought out right?
Recurring heating problems on a Hyundai I30 (3rd Generation) N
Broken thermostat
The concept is simple, in the case where the thermostat which regulates the temperature does not measure well the degree of heat of the cooling circuit, the totality of the latter is impacted. Even if the thermostat of your Hyundai I30 (3rd Generation) N still does not work properly, the heating will still work. Because the temperature coming from the engine block will increase progressively, then the cooling circuit at the same time, even without a thermostat. The only hassle is that you can't really change the heat emitted.
Air shutters blocked on the Hyundai I30 (3rd Generation) N
It's a concern that happens quite often. These shutters, which allow you to direct the air or adjust the intensity, sometimes get blocked over time. To remedy this it is simple, remove the cover and look inside how it was done. Activate the mechanisms to see where it is blocking. Put a little WD 40 to lubricate and voila.
Faulty fan on the Hyundai I30 (3rd Generation) N
As you might expect, the fan is only used at low speed or in neutral. If this heater does not send air at all at low speed and you still hear noise, it means that your fan has certainly failed. In principle, with a higher speed, the heating of your Hyundai I30 (3rd Generation) N should work. In case the fan really does not work it will have to be replaced.
Blocked hoses
The clues will be fairly simple. When your heating turns and creates little or no heat, the problem probably comes from the hoses. These become dirty over time and do not allow hot water to reach the heating of your Hyundai I30 (3rd Generation) N. So, clean the hoses or put new ones.
Air pocket in the circuit of the Hyundai I30 (3rd Generation) N
The symptom is sometimes the same as those of the hoses. If ever air pockets are stored in the circuit, hot water also has problems reaching the radiator of the heating of the Hyundai I30 (3rd Generation) N. Then, it will be enough to purge the circuit.
Conclusion
You now know what could cause the worry. However it is possible that the reason comes from elsewhere, like the air duct of your cluttered Hyundai I30 (3rd Generation) N, even a defective tap, but it is still quite rare. You can write a comment if this post has helped you. See you soon !