
How a heater works on a Kia Sorento 3
In the middle of winter it is a definite asset on the road when you go to work. And when the latter no longer works, we quickly regret it. So to know what is causing the malfunction, it is necessary to know how it works on the famous Kia Sorento 3, at least its principle. The heating uses the temperature of the engine block to increase the heat of the personalised tour, and very often the cooling device. In this way this system has several functions. Also, the fan device, so that the hot air reaches us also has a double use. It's the ventilateur which emits hot air when the vehicle is driving slowly or not at all, and it is the speed of your car that will send hot air when you are traveling faster. Pretty well thought out right?
Recurring heating problems on a Kia Sorento 3
Broken thermostat
The concept is affordable, assuming that the thermostat that regulates the temperature does not really capture the degree of heat of the cooling circuit, the whole of the latter is impacted. Even if the thermostat of the famous Kia Sorento 3 does not turn properly, the heating will still work. Because the temperature coming from the engine block will gradually increase, then the water circuit too, even without a thermostat. The only concern is that you cannot really regulate the heat emitted.
Air shutters blocked on the Kia Sorento 3
It is a dysfunction that happens quite frequently. These shutters, which allow you to direct the air or adjust the intensity, sometimes get blocked over time. To remedy this it is simple, remove the cover and look inside how it was done. Activate the mechanisms to see where it is blocking. Put a little WD 40 to lubricate and voila.
Faulty fan on the Kia Sorento 3
As you will understand, the fan is only used at reduced speed and stopped. If the heater does not emit any heat at low speed and you can still hear its noise, this means that your fan will most likely be defective. Ordinarily, with a higher speed the heating of the famous Kia Sorento 3 should work. If the fan does not rotate at all, it will need to be replaced.
Blocked hoses
His signs turn out to be rather simple. If your heating turns and does not heat or very little, the malfunction probably comes from the hoses. These clog up over time and do not allow hot water to reach the heating of the famous Kia Sorento 3. Therefore, clog the hoses or install new ones .
Air pocket in the Kia Sorento 3 circuit
The symptom happens to be identical to those of the hoses. If ever air bubbles are introduced into the circuit, water also has trouble reaching the radiator of the heating of this Kia Sorento 3. Therefore, it is only necessary to purge the water circuit.
Conclusion
You now know what will cause this dysfunction. However it may be that the problem comes from another place, for example the air duct of the famous Kia Sorento 3 blocked, or a defective tap, however it is still rarer. You can write a comment in case this post served you. Good walk !