heating-problem-Seat-600

How a heater works on a Seat 600

In the middle of winter it is our best ally on the way when we go to work. And when the latter does not work well we notice it quickly. Therefore, before finding out what causes the malfunction, it is necessary to understand how it works on your Seat 600, at least its principle. The heating use the temperature of the engine block so as to raise the temperature of the personalised tour, then very often from the cooling device. Therefore this system has several functions. Similarly, the emission device, so that the air arrives in the cabin has a double system. It's the ventilateur which emits air when the car is traveling at low speed or not, then it is the speed of your car which will send the air when you are traveling faster. Well designed, right?

Recurring heating problems on a Seat 600

Broken thermostat

The concept is easy, in the case where the thermostat which regulates the heat does not understand the temperature of the water circuit well, the whole of the latter is affected. Even if the thermostat of your Seat 600 still does not work properly, the heating will still work. Because the temperature produced by the engine block will increase progressively, and the water circuit at the same time, even without a thermostat. The only annoyance is that you will find it difficult to change the air temperature.

Air shutters blocked on the Seat 600

It is a dysfunction that happens quite often. These shutters, which allow you to direct the air or adjust the intensity, sometimes get blocked over time. To remedy this it is simple, remove the cover and look inside how it was done. Activate the mechanisms to see where it is blocking. Put a little WD 40 to lubricate and voila.

Faulty fan on the Seat 600

As you can imagine, the fan is effective only at low speed and the engine off. If your heating system does not generate air at low speed and you nevertheless hear a sound, it is good that the fan is probably running. A priori, thanks to more speed the heating of your Seat 600 will be able to work. If the fan really does not work it is better to replace it with a new one.

Blocked hoses

His clues will be fairly obvious. If your heating turns and does not generate little or no hot air, the malfunction certainly comes from the hoses. They become blocked over time and no longer allow hot water to reach the heating of your Seat 600. In this situation, clean the hoses or replace them with new ones.

Air pocket in the Seat 600 circuit

The symptom is the same as that of the hoses. If small pockets of air are introduced into the circuit, high temperature water will also have problems reaching the radiator of the heater of this Seat 600. In this situation, you just need to purge the circuit.

Conclusion

You now know what can cause your dysfunction. Nevertheless it happens that the concern comes from elsewhere, such as the air duct of your cluttered Seat 600, or a deficient tap, however it is still less frequent. You can write a comment if you liked this article. See you soon !