
How a heater works on a Seat Fura
When it's cold it's a definite asset on the road when you go to work. When it no longer works we easily miss it. In this case before knowing where the problem comes from, it is essential to know how it works on this Seat Fura, at least in a simplified way. The heating uses the temperature of the engine block to raise the temperature of the personalised tour, then generally the cooling system. So it's a two in one. Similarly, the fan system, so that the heat arrives in the cabin has a double system. There is a ventilateur which sends the heat when the car is running at low speed or is stopped, then it is the speed of the vehicle which will send the heat when you drive faster. Pretty well thought out right?
Recurring heating problems on a Seat Fura
Broken thermostat
The concept is simple, in the case where the thermostat which regulates the temperature does not measure well the degree of heat of the water circuit, the whole circuit is affected. Even if the thermostat of this Seat Fura does not work properly, the heating will work normally. Because the temperature produced by the engine block will increase progressively, and the cooling circuit too, whether it is regulated or not. Our only hassle is that you will have trouble setting the air temperature.
Air flaps blocked on the Seat Fura
It is a concern that happens quite regularly. These shutters, which allow you to direct the air or adjust the intensity, sometimes get blocked over time. To remedy this it is simple, remove the cover and look inside how it was done. Activate the mechanisms to see where it is blocking. Put a little WD 40 to lubricate and voila.
Faulty fan on the Seat Fura
As you can imagine, the fan only works at low speed and stopped. If your heater no longer generates air at low speed and you still hear its noise, this means that this fan turns out to be probably broken. Ordinarily, with more speed the heating of this Seat Fura should turn. If the fan does not work it should be changed.
Blocked hoses
The symptoms will be fairly obvious. When your heating works and does not generate very little or no hot air, the problem must certainly come from the hoses. They get dirty over time and no longer allow hot water to reach the heating of this Seat Fura. In this specific case, remove dirt from the hoses or replace them with new ones.
Air pocket in the Seat Fura circuit
The symptom is sometimes similar to that of the hoses. In the event that air bubbles are embedded inside the circuit, the high temperature water has the same problems to access the heating radiator of this famous Seat Fura. In this case, simply purge the circuit.
Conclusion
You now understand where this concern may come from. Nevertheless it is possible that the reason comes from elsewhere, such as the air duct of this blocked Seat Fura, or a broken tap, but it is all the same more rare. You can write a comment if this post has ever been useful to you. See you soon !