
How a heater works on a Suzuki Samurai
In the middle of winter it is a definite asset on the road when you go to work. When it does not work well we miss it ardently. So before knowing where the problem comes from, you need to know how it works on your Suzuki Samurai, at least its principle. The heating uses heat from the engine block to warm the personalised tour, and in most cases the cooling system. So it's a two in one. In addition, the emission system, so that the air arrives in the cabin also has a double use. There is a ventilateur which sends air as soon as the vehicle is traveling at low speed or not, and it is the speed of your automobile which allows air to be sent when you are traveling faster. Pretty well thought out right?
Recurring heating problems on a Suzuki Samurai
Broken thermostat
The idea is simple, when the thermostat that regulates the temperature does not really capture the degree of heat of the cooling circuit, the whole of the latter is affected. Even if the thermostat of your Suzuki Samurai still does not work properly, the heating will still work. Because the heat produced by the engine block will increase progressively, and the cooling circuit at the same time, even without a thermostat. The only annoyance is that you will not be able to really modify the heat emitted.
Air shutters blocked on the Suzuki Samurai
It is a concern that happens quite regularly. These shutters, which allow you to direct the air or adjust the intensity, sometimes get blocked over time. To remedy this it is simple, remove the cover and look inside how it was done. Activate the mechanisms to see where it is blocking. Put a little WD 40 to lubricate and voila.
Faulty fan on the Suzuki Samurai
As you might expect, the fan is useful only at low speed and in neutral. If it happens that the heating does not generate air at low speed but that you still discern noise, it is that the fan is most likely ruined. Ordinarily, with more speed, the heating of your Suzuki Samurai will be able to work. If the fan does not work at all, it will have to be replaced by a new one.
Blocked hoses
The symptoms turn out to be quite simple. When your heating blows but does not generate very little hot air, the problem must certainly come from the hoses. These become blocked over time and no longer allow hot water to reach the heating of your Suzuki Samurai. In this situation, clean the hoses or put new ones.
Air pocket in the circuit of the Suzuki Samurai
The symptom happens to be identical to that of the hoses. If it happens that air pockets are embedded inside the circuit, the water will also have problems accessing the radiator of the Suzuki Samurai heater. In this situation, it will suffice to purge the water circuit.
Conclusion
You now know where the worry will come from. That said, the reason may have come from another location, such as the air duct of your clogged Suzuki Samurai, or a defective valve, but it is still quite rare. Do not hesitate to leave a comment in case this post was useful to you. Good walk !