
How a heater works on a Toyota Pod
In the middle of winter, heating is a definite asset on the trip when you go to work. And when the latter does not turn out well, we quickly regret it. So before knowing where the malfunction came from, it is essential to understand how it works on your Toyota Pod, at least its principle. The heating exploits engine temperature to increase heat personalised tour, then generally the cooling device. In fact, this duplicates. Also, the emission device, so that the hot air reaches us also presents a duplication. It's the ventilateur which emits hot air when the car is driving at low speed or not at all, then it is the speed of the vehicle which allows hot air to be sent when you are driving faster. It's pretty clever isn't it?
Recurring heating problems on a Toyota Pod
Broken thermostat
The concept is simple, in the case where the thermostat which makes it possible to regulate the temperature does not really enter the temperature of the water circuit, the whole of the latter is affected. Even if the thermostat on your Toyota Pod does not work well, the heating will still work. Quite simply because the temperature produced by the engine will increase over time, then the water circuit too, whether it is regulated or not. The only hassle is that you can't really adjust the air temperature.
Air shutters blocked on the Toyota Pod
It is a dysfunction that happens quite regularly. These shutters, which allow you to direct the air or adjust the intensity, sometimes get blocked over time. To remedy this it is simple, remove the cover and look inside how it was done. Activate the mechanisms to see where it is blocking. Put a little WD 40 to lubricate and voila.
Defective fan on the Toyota Pod
You have now entered, the fan is only used at low speed and stopped. If this heater does not generate too much heat at low speed and you nevertheless hear noise, it means that your fan is probably going to run out. A priori, thanks to a fast pace the heating of your Toyota Pod must turn. If the fan really does not work it is better to change it.
Blocked hoses
Its signs will be rather simple. If your heating works and does not heat or very little, the malfunction must probably come from the hoses. These clog up over time and no longer allow hot water to access the heating of your Toyota Pod. In this case, remove the hoses or put new ones.
Air pocket in the Toyota Pod circuit
The syndrome is found to be identical to that of the durits. If ever air bubbles are introduced into the circuit, the water will also have problems reaching the radiator of the heating of this Toyota Pod. In this case, it will suffice to purge the water circuit.
Conclusion
You now understand where this malfunction can occur. However it may be that the reason comes from elsewhere, such as the air duct of your cluttered Toyota Pod, or a broken valve, however it is unfortunately rather rare. Do not hesitate to leave a comment in case this post served you. Good walk !