Having a front wiper malfunction is not uncommon. It is even one of the most usual malfunctions, and not just on the Renault Kangoo 2. The windshield wipers have moreover become consumables, owing to the fact that they deteriorate rapidly and are simple to change . But the malfunctions can be quite different, and the reasons will therefore vary. It can come from broom , engine , or a electrical malfunction especially. We will therefore see the most usual symptoms and how to remedy them.wiper-front-Renault-Kangoo-2

Complete failure of the front wiper of your Renault Kangoo 2

The malfunction must undoubtedly come from the motor of your front wiper. When you want to check it, you will need to measure the electrical current at the input of the wiper motor. However, this is a precaution that is not absolutely necessary. The fault is probably due to the engine. In this situation, you will need to obtain a new engine, suitable for your Renault Kangoo 2 . It is also conceivable that the dysfunction comes from broom training . In this situation, make it activate manually. When the latter can move on its pivot without problem, it is because it shows no malfunction.

The front wiper of your Renault Kangoo 2 is noisy

A noisy front wiper on a Renault Kangoo 2 is not a major malfunction, however it is undoubtedly quickly annoying. If you ever notice shrill noise is that it comes from the wear of the rubber blade of the broom. As if you were running it on your dry windshield. In this situation it will certainly have to be replaced. When it is a squeaky noise , it is certainly the training which is a bit seized. It then suffices to oil it, and the malfunction will be resolved.

Renault Kangoo 2's front wipers don't go at the right speed

This time it is a malfunction which can be problematic, especially during torrential rains and the front wipers are abnormally slow. For comparison, at maximum speed, the speed is approximately one round trip per second. If they are actually slower, the causes can be multiple. But there is a good chance that it is the engine that is at fault. You can always remove components to see what is holding back the process. Be careful not to damage your windshield. It is also conceivable that the state of wear of the brush slows down the operation. In this situation, it will suffice to replace brushes .