Having a front wiper malfunction is not uncommon. This is one of the most usual problems, and not just on the Renault Kangoo Rx-4. Windshield wipers have become consumable because they wear out easily and are easy to replace . But the problems can be quite different, and the causes will therefore vary. This can be from broom , engine , or a electrical malfunction to name just that. We will see the most usual symptoms, and how to remedy them.front-wiper-Renault-Kangoo-Rx-4

Complete failure of the front wiper of your Renault Kangoo Rx-4

The malfunction undoubtedly comes from the motor of your front wiper. In case you are looking to check it, you will need to measure the electrical current at the input of the wiper motor. But it is a precaution that is not absolutely mandatory. The fault is probably due to the engine. In this case, you will have to buy a new engine, suitable for your Renault Kangoo Rx-4 . It is also possible that the malfunction comes from broom training . In this situation, activate it manually. If the latter moves on its axis without problem, it means that it does not have any malfunction.

The front wiper of your Renault Kangoo Rx-4 is noisy

A noisy front wiper on a Renault Kangoo Rx-4 is not a major malfunction, however it is certainly quickly annoying. If you ever notice shrill noise is that it comes from the wear of the rubber blade of the broom. As if you were operating it on the dry windshield. In this situation, you probably need to replace it. In case it is a squeaky noise , it is certainly the training which is slightly seized. It then suffices to oil it, and the malfunction will be resolved.

Renault Kangoo Rx-4's front wipers don't go at the right speed

This time it is a malfunction which can be dangerous, especially during torrential rain and the front wipers turn out to be particularly slow. For comparison, at maximum speed, the speed is about one round trip per second. If they are indeed much slower, the causes can be multiple. But there is a good chance that it is the engine that is at fault. You can always remove components to distinguish what slows the mechanism. Be careful not to damage the windshield. It is also likely that wear and tear on the broom slows the mechanism. In this situation, you just need to replace brushes .