Having a front wiper issue is not uncommon. It is even one of the most frequent concerns, and not only on the Toyota Rav 4 (3rd Generation). Windshield wipers have become consumables because they wear out quickly and are simple to replace . But the concerns can be quite different, and the reasons will therefore vary. This can be from broom , engine , or a electrical concern to name just that. We will therefore see the most frequent symptoms, then how to alleviate them.wiper-before-Toyota-Rav-4- (3rd-Generation)

Complete failure of the front wiper of your Toyota Rav 4 (3rd Generation)

The problem is undoubtedly the engine of your front wiper. When you want to check it, you can measure the electrical current on the wiper motor. However, this is a precaution that is not fundamentally necessary. The fault is probably due to the engine. In this situation, you will need to obtain a new engine, suitable for your Toyota Rav 4 (3rd Generation) . It is also plausible that the concern comes from broom training . In this situation, activate it manually. When the latter can move on its pivot perfectly, it means that it shows no problem.

The front wiper of your Toyota Rav 4 (3rd Generation) is noisy

A noisy front wiper on a Toyota Rav 4 (3rd Generation) is not a serious concern, but it is quickly annoying. If you ever see a shrill noise is that it comes from the wear of the rubber blade of the broom. As if you were running it on your dry windshield. In this situation, you probably need to replace it. When it is a squeaky noise , it’s probably the training that’s a bit seized. In this case, it will suffice to lubricate it, and the problem will be resolved.

The front wipers of the Toyota Rav 4 (3rd Generation) are not going at the right speed

This time it is a concern that can be problematic, especially during heavy rain and that the front wipers turn out to be particularly slow. For comparison, at maximum speed, the speed is approximately one round trip per second. If they are indeed slower, the reasons could be multiple. But there is a strong probability that it is the engine that is the cause. You can always dismantle elements to discern what is holding back the process. Be careful not to scratch the windshield. It is also possible that the state of wear of the brush slows down the operation. In this situation, you just need to replace brushes .