When you want to go on vacation, there is nothing more unpleasant than an inaccessible safe. And everyone knows, locksmithing is a very expensive area. Especially on a vehicle, because if it is necessary to change the lock of the trunk, it must be done on each of the other doors of the Mazda Rx-7 (2nd Generation). So before getting a quote from a locksmith, we will see if there are not cheaper solutions by carrying out repairs yourself. For this, we will go around the most usual problems and what will be the possible solutions to this problem.
The key no longer fits fully in the trunk lock of the Mazda Rx-7 (2nd Generation)
The problem can arise from a variety of reasons. First is that your key is bent. If so, you'd be hard pressed to open the doors of the Mazda Rx-7 (2nd Generation). You will then have to test to gently curve it. Otherwise, it is also conceivable that the lock is only congested. You must then grease the lock or insert anti-seize such as WD40. By dint of turning the key without forcing too much, the lock should eventually activate. It is practically impossible for a resistant element to fit into the trunk lock, unless someone has tried to force it.
The key turns in the lock, however the trunk of the Mazda Rx-7 (2nd Generation) does not open
The first step is to infiltrate through a door and try to open the trunk from the inside. If there too nothing happens, then the lock of your Mazda Rx-7 (2nd Generation) is certainly in bad condition. You can still put an anti-seize inside the system, but honestly there is little chance that it will work. Unfortunately, that leaves you with a unique solution: go see your locksmith.
The lock on the trunk of my Mazda Rx-7 (2nd Generation) is completely blocked
You can enter your key completely into the Mazda Rx-7 (2nd Generation) lock, however impossible to rotate . In this situation, a simple observation must be made. If this is also the case on the doors, it is because the problem comes from the key, naturally. If on the other hand this is only the case on the trunk, it is of course the lock that blocks. Therefore, the first thing to do is to introduce WD40. This anti-seize is the most used in mechanics. In general it solves more problems than you might think. It is also conceivable that an element has entered the lock and blocks its proper functioning. In this situation, a locksmith can help you. Last solution, change the lock…